# Makefile # You can edit this file or override these variables on # the commandline. For example, "make install MANDIR=/tmp/man" # would use defaults for all variables except ${MANDIR}. # You can set this to something like /opt/aoetools-x # if you want to install everything in one place. # # Note that even with ${PREFIX} set, the devices in # /dev/etherd will be used unless you override ${DEVDIR}. PREFIX = # Your aoe-driver device files should be in ${DEVDIR}. DEVDIR = /dev/etherd # The programs will be installed in ${SBINDIR}. SBINDIR = ${PREFIX}/usr/sbin MANDIR = ${PREFIX}/usr/share/man # NPERSHELF is the number of slot addresses per shelf address. # This number must match the same setting in the aoe driver. # # Older aoe drivers have NPERSHELF set to 10, and newer ones # use 16. # # You can see the setting in your driver like this in the driver # source directory. (Change into the "linux" directory if you're # using the standalone driver from the Coraid.) # # grep 'NPERSHELF.*=' drivers/block/aoe/aoe.h # NPERSHELF=16 # end of user-configurable variables # these scripts are created from the *.in files CONF_SCRIPTS = aoe-discover aoe-interfaces aoe-mkshelf aoe-revalidate PROGS = aoeping COMMANDS := ${CONF_SCRIPTS} aoe-mkdevs aoe-stat ${PROGS} CFLAGS = -Wall -O -g AOE_PING_OBJ = aoeping.o linux.o all : configure ${PROGS} @true configure : @for f in ${CONF_SCRIPTS}; do \ sh -xc "sed -e 's!@devdir@!${DEVDIR}!g' -e 's!@npershelf@!${NPERSHELF}!g' $$f.in > $$f" || break; \ done install : all mkdir -p ${SBINDIR} mkdir -p ${MANDIR}/man8 @for f in ${COMMANDS}; do \ sh -xc "install -m 700 $$f ${DESTDIR}${SBINDIR}/$$f" || break; \ sh -xc "install -m 664 $$f.8 ${DESTDIR}${MANDIR}/man8/$$f.8" || break; \ done clean : rm -f ${CONF_SCRIPTS} ${AOE_PING_OBJ} ${PROGS} aoeping : ${AOE_PING_OBJ} ${CC} ${CFLAGS} -o $@ ${AOE_PING_OBJ} aoeping.o : aoeping.c dat.h fns.h ${CC} ${CFLAGS} -o $@ -c $< linux.o : linux.c config.h ${CC} ${CFLAGS} -o $@ -c $<