Christoph Biedl
8b819822c0
Load PPTP NAT helper kernel module. Closes: #780181
|
9 years ago | |
|---|---|---|
| .. | ||
| patches | 9 years ago | |
| source | 12 years ago | |
| README.debian | 12 years ago | |
| bcrelay.docs | 12 years ago | |
| bcrelay.install | 12 years ago | |
| changelog | 10 years ago | |
| compat | 12 years ago | |
| control | 9 years ago | |
| copyright | 11 years ago | |
| pptpd-options | 12 years ago | |
| pptpd.conf | 12 years ago | |
| pptpd.default | 12 years ago | |
| pptpd.docs | 12 years ago | |
| pptpd.init | 11 years ago | |
| pptpd.install | 12 years ago | |
| pptpd.modprobe | 9 years ago | |
| pptpd.service | 11 years ago | |
| rules | 9 years ago | |
| watch | 11 years ago | |
README.debian
IP forwarding
-------------
Please note: If you want to use pptpd to create host-to-site tunnels
(e.g. typical road-warrior setups), then you will need to enable IP
forwarding. This can be done by un-commenting
net.ipv4.ip_forward=1
in /etc/sysctl.conf.
Support for non-Linux
---------------------
For the time being, pptpd is restricted to Linux only. Patches to
re-enable support for other platforms are welcome.
Issues on kfreebsd:
* bcrelay does not compile. Workaround: Disable bcrelay
* There's no pppd here but freebsd-ppp instead. Appearently it has a
completely different parameter usage.
Issues on hurd:
* bcrelay does not compile. Workaround: Disable bcrelay
* No ppp at all.
-------------
Please note: If you want to use pptpd to create host-to-site tunnels
(e.g. typical road-warrior setups), then you will need to enable IP
forwarding. This can be done by un-commenting
net.ipv4.ip_forward=1
in /etc/sysctl.conf.
Support for non-Linux
---------------------
For the time being, pptpd is restricted to Linux only. Patches to
re-enable support for other platforms are welcome.
Issues on kfreebsd:
* bcrelay does not compile. Workaround: Disable bcrelay
* There's no pppd here but freebsd-ppp instead. Appearently it has a
completely different parameter usage.
Issues on hurd:
* bcrelay does not compile. Workaround: Disable bcrelay
* No ppp at all.